TM 5-3895-376-14&P
4-26. CLUTCH ASSEMBLY MAINTENANCE INSTRUCTIONS - Continued
4.
Unhook the springs (5) from the brake shoes (3),
from the ball bearing installed in the clutch hous-
and separate the brake shoes and weights,
ing (4).
5.
Clean the weights and springs off with a clean
5.
Using snap ring plier, remove the inner retaining
rag.
ring (5).
6.
Install replacement brake shoes (3) over
6.
Remove the four screws (6), outer and inner
weights (4) and hook two springs on each side.
shields (7 and 8).
7.
Install the assembled brake shoes, weights and
7.
Separate assembled brake shoes (10),
springs into the clutch housing by pulling the
weights (11), and springs (9) from the center
brake shoes apart and seating the weights and
shaft (3).
brake shoes around the center shaft.
8.
Remove the four springs (9) and separate the
8.
Install the outer shield (2) and secure with two
brake shoes (10) and weights (11).
screws (1).
9.
Remove threaded plug (12).
10. Using snap ring plier, remove the retaining
1.
Using snap ring plier, remove the outer retaining
ring (13) from inside the clutch housing (4).
ring (1).
2.
Pry the dust cover (2) from bore of clutch hous-
ing (4).
3.
Place the clutch assembly on blocking (approxi-
mately 4 inches (102 mm) high) that supports the
pulley flange of the clutch assembly with the cen-
ter shaft (2) hanging down.
4.
With wood block or brass drift, tap on the end of
the center shaft (3) to drive the shaft assembly
4-45
