TM 5-3895-376-14&P
4-25. V-BELT MAINTENANCE INSTRUCTIONS
This task includes:
c. Replace
a. Inspect
b. Adjust
INITIAL SETUP
Equipment Condition
Tools
Compactor set on level ground.
Tool Kit, General Mechanic's
Engine off.
Materials/Parts
V-belt covers off.
V-belt (1)
General Safety Instructions
Lockwasher, M8 (8)
Observe all WARNINGS and CAUTIONS
If v-belt cover has not been removed, remove the
1.
cover as follows:
a.
Remove four capscrews (1), lockwashers (2),
and flat washers (3).
b.
Remove the v-belt cover (4) from engine
Inspect v-belt for wear, cracks or deterioration.
2.
If v-belt appears in good condition, check tension
3.
by deflecting the v-belt at point indicated. V-belt
is at proper tension if the amount of deflection is
approximately 3/8 in. (10 mm). If belt tension is
greater or less than 3/8 in. (10 mm), adjust ten-
sion.
If v-belt is defective replace the v-belt.
4.
Adjust v-belt tension by loosening the hex nuts,
1.
and turning the eccentrics. Turning the larger off-
set of the eccentric toward the stop bar welded to
the engine base, will increase tension on the v-
belt. Turning the large offset away from stop bar
will decrease tension.
When tension has been adjusted to achieve ap-
2.
proximately 3/8 in. (10 mm), secure adjustment
by tightening the hex nuts securely.
4-42
