TM 5-3805-296-23-1
0062
Table 1. 0600 Hydraulic Oil Temperature Sensor Diagnostic Codes Continued.
062
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
3. Disconnect connector A-C1
0600-08 Hydraulic Oil
(WP 0012, Figure 106)
Temperature Sensor
from connector J-C3
Abnormal Signal
(WP 0012, Figure 101).
Continued
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 6.
between connector A-C1
Resistance Greater Than 5.0 Ohms
terminal 2 and terminal 3
Replace transmission wiring harness
(WP 0012, Figure 106).
(WP 0266).
Proceed to Test Step 18.
Test Step 6. Test Chassis Wiring
Harness for High Resistance or
Open.
1. Remove jumper wire from terminal
6 and terminal 7 of connector A-C6
(WP 0012, Figure 134).
2. Connect jumper wire between
terminal 2 and terminal 3
of connector J-C3
(WP 0012, Figure 101).
3. Disconnect connector J-C8
(WP 0012, Figure 100)
from connector W-C1
(WP 0012, Figure 99).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 7.
between connector J-C8
Resistance Greater Than 5.0 Ohms
terminal 11 and terminal 46
Replace chassis wiring harness
(WP 0012, Figure 100).
(WP 0305).
Proceed to Test Step 18.
Test Step 7. Test Main Cab Wiring
Harness for High Resistance or
Open.
1. Remove jumper wire from
terminal 2 and terminal 3
of connector J-C3
(WP 0012, Figure 101).
2. Connect jumper wire between
terminal 11 and terminal 46
of connector W-C1
(WP 0012, Figure 99).
3. Disconnect connector W-C12
(WP 0012, Figure 88) from
transmission/chassis ECM.
0062-16