TM 5-3805-296-23-1
0062
Table 1. 0600 Hydraulic Oil Temperature Sensor Diagnostic Codes Continued.
062
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 3. Test Hydraulic Temp
0600-08 Hydraulic Oil
Sensor Circuit, 8 Volt Sensor Supply
Temperature Sensor
Circuit, and Ground Circuit Function.
Abnormal Signal
1. Turn battery disconnect switch and
Continued
ignition switch to ON position
(TM 5-3805-296-10).
2. Using digital multimeter
Voltage 4.6 to 5.4 V Proceed to
(WP 0540), test for voltage
step 3.
between connector C-C5
Voltage Less Than 4.6 V Proceed to
terminal C and terminal B
Test Step 4.
(WP 0012, Figure 132).
3. Using digital multimeter
Voltage 7.6 to 8.4 V Proceed to Test
(WP 0540), test for voltage
Step 8.
between connector C-C5
Voltage Less Than 7.6 V Proceed to
terminal A and terminal B
Test Step 14.
(WP 0012, Figure 132).
Test Step 4. Test Cushion Hitch
Wiring Harness for High Resistance
or Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Connect jumper wire between
terminal C and terminal B
of connector C-C5
(WP 0012, Figure 132).
3. Disconnect connector A-C6
(WP 0012, Figure 134)
from connector C-C1
(WP 0012, Figure 133).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 5.
between connector C-C1
Resistance Greater Than 5.0 Ohms
terminal 6 and terminal 7
Replace cushion hitch wiring harness
(WP 0012, Figure 133).
(WP 0400).
Proceed to Test Step 18.
Test Step 5. Test Transmission
Wiring Harness for High Resistance
or Open.
1. Remove jumper wire from
terminal C and terminal B
of connector C-C5
(WP 0012, Figure 132).
2. Connect jumper wire between
terminal 6 and terminal 7
of connector A-C6
(WP 0012, Figure 134).
0062-15