TM 5-3805-296-23-1
0062
Table 1. 0600 Hydraulic Oil Temperature Sensor Diagnostic Codes Continued.
062
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
4. Using digital multimeter
0600-08 Hydraulic Oil
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Temperature Sensor
Replace transmission/chassis ECM
between connector W-C12
Abnormal Signal
(WP 0495).
terminal 12 and terminal 16
Continued
Proceed to Test Step 18.
(WP 0012, Figure 88).
Resistance Greater Than 5.0 Ohms
Replace main cab wiring harness
(WP 0505).
Proceed to Test Step 18.
Test Step 8. Inspect Cushion Hitch
Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector A-C6
(WP 0012, Figure 134)
from connector C-C1
(WP 0012, Figure 133).
3. Inspect connector C-C1
Connector C-C1 Damaged Replace
(WP 0012, Figure 133) for
cushion hitch wiring harness
damage IAW Electrical General
(WP 0400).
Maintenance Procedures
Proceed to Test Step 18.
(WP 0540).
No Problem Found Proceed to Test
Step 9.
Test Step 9. Inspect Transmission
Wiring Harness.
1. Disconnect connector A-C1
(WP 0012, Figure 106)
from connector J-C3
(WP 0012, Figure 101).
2. Inspect connector A-C6 (WP 0012,
Connector A-C6 or A-C1 Damaged
Figure 134) and connector A-C1
Replace transmission wiring harness
(WP 0012, Figure 106) for
(WP 0266).
damage IAW Electrical General
Proceed to Test Step 18.
Maintenance Procedures
No Problem Found Proceed to Test
(WP 0540).
Step 10.
Test Step 10. Inspect Chassis Wiring
Harness.
1. Disconnect connector J-C8
(WP 0012, Figure 100)
from connector W-C1
(WP 0012, Figure 99).
0062-17