TM 5-3805-296-23-1
0062
Table 1. 0600 Hydraulic Oil Temperature Sensor Diagnostic Codes Continued.
062
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 17. Test Main Cab Wiring
0600-08 Hydraulic Oil
Harness for High Resistance or
Temperature Sensor
Open.
Abnormal Signal
1. Remove jumper wire from terminal
Continued
1 and terminal 3 of connector J-C3
(WP 0012, Figure 101).
2. Connect jumper wire between
terminal 11 and terminal 16 of
connector W-C1 (WP 0012,
Figure 99).
3. Disconnect connector W-C12
(WP 0012, Figure 88) from
transmission/chassis ECM.
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Replace transmission/chassis ECM
between connector W-C12
(WP 0495).
terminal 11 and terminal 12
Proceed to Test Step 18.
(WP 0012, Figure 88).
Resistance Greater Than 5.0 Ohms
Replace main cab wiring harness
(WP 0505).
Proceed to Test Step 18.
Test Step 18. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
3. At MSD, check for active
600-8 Hydraulic Oil Temperature
diagnostic codes (WP 0008).
Sensor Abnormal Signal Becomes
Inactive Troubleshooting complete.
600-8 Hydraulic Oil Temperature
Sensor Abnormal Signal Remains
Active Repeat troubleshooting from
the beginning.
END OF WORK PACKAGE
0062-21/(22 blank)