TM 5-3805-296-23-1
0062
Table 1. 0600 Hydraulic Oil Temperature Sensor Diagnostic Codes Continued.
062
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 15. Test Transmission
0600-08 Hydraulic Oil
Wiring Harness for High Resistance
Temperature Sensor
or Open.
Abnormal Signal
1. Remove jumper wire from terminal
Continued
A and terminal B of connector C-
C5 (WP 0012, Figure 132).
2. Connect jumper wire between
terminal 5 and terminal 7
of connector A-C6
(WP 0012, Figure 134).
3. Disconnect connector A-C1
(WP 0012, Figure 106)
from connector J-C3
(WP 0012, Figure 101).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 16.
between connector A-C1
Resistance Greater Than 5.0 Ohms
terminal 1 and terminal 3
Replace transmission wiring harness
(WP 0012, Figure 106).
(WP 0266).
Proceed to Test Step 18.
Test Step 16. Test Chassis Wiring
Harness for High Resistance or
Open.
1. Remove jumper wire from
terminal 5 and terminal 7 of
connector A-C6
(WP 0012, Figure 134).
2. Connect jumper wire between
terminal 1 and terminal 3
of connector J-C3
(WP 0012, Figure 101).
3. Disconnect connector J-C8
(WP 0012, Figure 100) f
rom connector W-C1
(WP 0012, Figure 99).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 17.
between connector J-C8
Resistance Greater Than 5.0 Ohms
terminal 11 and terminal 16
Replace chassis wiring harness
(WP 0012, Figure 100).
(WP 0305).
Proceed to Test Step 18.
0062-20