TM 5-3805-296-23-1
0062
Table 1. 0600 Hydraulic Oil Temperature Sensor Diagnostic Codes Continued.
062
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
2. Inspect connector J-C3
0600-08 Hydraulic Oil
Connector J-C3 or J-C8 Damaged
(WP 0012, Figure 101)
Temperature Sensor
Replace chassis wiring harness
and connector J-C8
Abnormal Signal
(WP 0305).
(WP 0012, Figure 100) for
Continued
Proceed to Test Step 18.
damage IAW Electrical General
No Problem Found Proceed to Test
Maintenance Procedures
Step 11.
(WP 0540).
Test Step 11. Inspect Main Cab
Wiring Harness.
1. Disconnect connector W-C12
(WP 0012, Figure 88) from
transmission/chassis ECM.
2. Inspect connector W-C1
Connector W-C1 or W-C12 Damaged
(WP 0012, Figure 99), connector
Replace main cab wiring harness
W-C12 (WP 0012, Figure 88), and
(WP 0505).
transmission/chassis ECM for
Proceed to Test Step 18.
damage IAW Electrical General
Transmission/Chassis ECM
Maintenance Procedures
Damaged Replace transmission/
(WP 0540).
chassis ECM (WP 0495).
Proceed to Test Step 18.
No Problem Found Proceed to Test
Step 12.
Test Step 12. Verify if Code is Still
Active.
1. Connect connector W-C12
(WP 0012, Figure 88) to
transmission/chassis ECM.
2. Connect connector J-C8
(WP 0012, Figure 100)
to connector W-C1
(WP 0012, Figure 99).
3. Connect connector A-C1
(WP 0012, Figure 106)
to connector J-C3
(WP 0012, Figure 101).
4. Connect connector A-C6
(WP 0012, Figure 134)
to connector C-C1
(WP 0012, Figure 133).
5. Connect connector C-C5
(WP 0012, Figure 132) to hydraulic
oil temperature sensor connector
(WP 0012, Figure 131).
6. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
0062-18