TM 5-3805-296-23-1
0062
Table 1. 0600 Hydraulic Oil Temperature Sensor Diagnostic Codes Continued.
062
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 1. Check for Other Active
0600-08 Hydraulic Oil
Codes.
Temperature Sensor
1. Turn battery disconnect switch and
Abnormal Signal
ignition switch to ON position
Continued
(TM 5-3805-296-10).
41-3 8 Volt DC Supply Voltage Above
2. Connect MSD. Select
Normal Active Diagnose and repair
Transmission 621G and check for
active code (WP 0053).
active diagnostic code:
41-4 8 Volt DC Supply Voltage Below
a. 41-3 8 Volt DC Supply Voltage
Normal Active Diagnose and repair
Above Normal.
active code (WP 0053).
b. 41-4 8 Volt DC Supply Voltage
600-3 Hydraulic Oil Temperature
Below Normal.
Sensor Voltage Above Normal Active
c.
600-3 Hydraulic Oil
Diagnose and repair active code as
Temperature Sensor Voltage
described in this work package.
Above Normal.
600-4 Hydraulic Oil Temperature
d. 600-4 Hydraulic Oil
Sensor Voltage Below Normal Active
Temperature Sensor Voltage
Diagnose and repair active code as
Below Normal (WP 0008).
described in this work package.
Only 600-8 Hydraulic Oil
Temperature Sensor Abnormal
Signal Active Proceed to Test Step 2.
Test Step 2. Inspect Cushion Hitch
Wiring Harness and Hydraulic Oil
Temperature Sensor Connectors.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector C-C5
(WP 0012, Figure 132) from
hydraulic oil temperature sensor
connector (WP 0012, Figure 131).
3. Inspect connector C-C5
Connector C-C5 Damaged - Replace
(WP 0012, Figure 132) and
cushion hitch wiring harness
hydraulic oil temperature sensor
(WP 0400).
connector (WP 0012, Figure 131)
Proceed to Test Step 18.
for damage IAW Electrical General
Hydraulic Oil Temperature Sensor
Maintenance Procedures
Connector Damaged - Replace
(WP 0540).
hydraulic oil temperature sensor
(WP 0314).
Proceed to Test Step 18.
No Problem Found - Proceed to Test
Step 3.
0062-14
