TM 5-3805-296-23-1
0062
Table 1. 0600 Hydraulic Oil Temperature Sensor Diagnostic Codes Continued.
062
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 14. Verify Malfunction is
0600-03 Hydraulic Oil
Resolved.
Temperature Sensor Voltage
1. Ensure all harness connectors are
Above Normal Continued
connected.
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
3. At MSD, check for active
600-3 Hydraulic Oil Temperature
Sensor Voltage Above Normal
diagnostic codes (WP 0008).
Becomes Inactive Troubleshooting
complete.
600-3 Hydraulic Oil Temperature
Sensor Voltage Above Normal
Remains Active Repeat
troubleshooting from the beginning.
NOTE
0600-04 Hydraulic Oil
Temperature Sensor Voltage
Always inspect harness connectors that are involved in the circuit. Poor
Below Normal
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
DIAGNOSTIC CODE SET CONDITION
Transmission/Chassis ECM Detects Below Normal Voltage on Hydraulic
Temperature Sensor Circuit R732.
POSSIBLE CAUSE
Cushion Hitch Wiring Harness Shorted.
Transmission Wiring Harness Shorted.
Chassis Wiring Harness Shorted.
Main Cab Wiring Harness Shorted.
Hydraulic Oil Temperature Sensor.
Transmission/Chassis ECM.