TM 5-3805-296-23-1
0062
Table 1. 0600 Hydraulic Oil Temperature Sensor Diagnostic Codes Continued.
062
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 1. Test for Shorted
0600-04 Hydraulic Oil
Hydraulic Oil Temperature Sensor.
Temperature Sensor Voltage
1. Turn ignition switch and battery
Below Normal Continued
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector C-C5
(WP 0012, Figure 132) from
hydraulic oil temperature sensor
connector (WP 0012, Figure 131).
3. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
600-3 Hydraulic Oil Temperature
4. At MSD, check for active
Sensor Voltage Above Normal
diagnostic code 600-4 Hydraulic
Becomes Active Replace hydraulic
Oil Temperature Sensor Voltage
oil temperature sensor (WP 0314).
Below Normal (WP 0008).
Proceed to Test Step 6.
600-4 Hydraulic Oil Temperature
Sensor Voltage Below Normal
Remains Active Proceed to Test
Step 2.
Test Step 2. Test for Shorted
Cushion Hitch Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector A-C6
(WP 0012, Figure 134)
from connector C-C1
(WP 0012, Figure 133).
3. Using digital multimeter
Continuity Replace cushion hitch
(WP 0540), test for continuity
wiring harness (WP 0400).
between connector C-C1
Proceed to Test Step 6.
terminal 6 (WP 0012, Figure 133)
No Continuity Proceed to step 4.
and all other terminals
in connector C-C1
(WP 0012, Figure 133).
4. Using digital multimeter
Continuity Replace cushion hitch
(WP 0540), test for continuity
wiring harness (WP 0400).
between connector C-C1
Proceed to Test Step 6.
terminal 6 (WP 0012, Figure 133)
No Continuity Proceed to Test
and ground.
Step 3.
0062-10