TM 5-3805-296-23-1
0062
Table 1. 0600 Hydraulic Oil Temperature Sensor Diagnostic Codes Continued.
062
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 6. Test Cushion Hitch
0600-03 Hydraulic Oil
Wiring Harness for High Resistance
Temperature Sensor Voltage
or Open.
Above Normal Continued
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Connect jumper wire between
terminal C and terminal B
of connector C-C5
(WP 0012, Figure 132).
3. Disconnect connector A-C6
(WP 0012, Figure 134)
from connector C-C1
(WP 0012, Figure 133).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 7.
between connector C-C1
Resistance Greater Than 5.0 Ohms
terminal 6 and terminal 7
Replace cushion hitch wiring harness
(WP 0012, Figure 133).
(WP 0400).
Proceed to Test Step 14.
Test Step 7. Test Transmission
Wiring Harness for High Resistance
or Open.
1. Remove jumper wire from terminal
C and terminal B of connector
C-C5 (WP 0012, Figure 132).
2. Connect jumper wire between
terminal 6 and terminal 7
of connector A-C6
(WP 0012, Figure 134).
3. Disconnect connector A-C1
(WP 0012, Figure 106)
from connector J-C3
(WP 0012, Figure 101).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 8.
between connector A-C1
Resistance Greater Than 5.0 Ohms
terminal 2 and terminal 3
Replace transmission wiring harness
(WP 0012, Figure 106).
(WP 0266).
Proceed to Test Step 14.
0062-5
