TM 5-3805-296-23-1
0062
Table 1. 0600 Hydraulic Oil Temperature Sensor Diagnostic Codes Continued.
062
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
5. Using digital multimeter
0600-03 Hydraulic Oil
Voltage 7.6 to 8.4 V Replace
(WP 0540), test for voltage
Temperature Sensor Voltage
hydraulic oil temperature sensor
between connector C-C5
Above Normal Continued
(WP 0314).
terminal A and terminal B
Proceed to Test Step 14.
(WP 0012, Figure 132).
Voltage Less Than 7.6 V Proceed to
Test Step 10.
Test Step 2. Test for Shorted
Cushion Hitch Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector A-C6
(WP 0012, Figure 134)
from connector C-C1
(WP 0012, Figure 133).
3. Using digital multimeter
Continuity Replace cushion hitch
(WP 0540), test for continuity
wiring harness (WP 0400).
between connector C-C1
Proceed to Test Step 14.
terminal 6 (WP 0012, Figure 133)
No Continuity Proceed to Test
and all other terminals
Step 3.
in connector C-C1
(WP 0012, Figure 133).
Test Step 3. Test for Shorted
Transmission Wiring Harness.
1. Disconnect connector A-C1
(WP 0012, Figure 106)
from connector J-C3
(WP 0012, Figure 101).
2. Using digital multimeter
Continuity Replace transmission
(WP 0540), test for continuity
wiring harness (WP 0266).
between connector A-C6
Proceed to Test Step 14.
terminal 6 (WP 0012, Figure 134)
No Continuity Proceed to step 3.
and all other terminals
in connector A-C6
(WP 0012, Figure 134).
3. Using digital multimeter
Continuity Replace transmission
(WP 0540), test for continuity
wiring harness (WP 0266).
between connector A-C1
Proceed to Test Step 14.
terminal 2 (WP 0012, Figure 106)
No Continuity Proceed to Test
and all other terminals
Step 4.
in connector A-C1
(WP 0012, Figure 106).
0062-3
