TM 5-3895-376-14&P
5-14. GEAR COVER MAINTENANCE INSTRUCTIONS
This task includes:
d. Repair
a. Remove
e. Installation
b. Cleaning
c. Inspection
INITIAL SETUP
Gasket, Cover (1)
Tools
Gasket, Access Cover (1)
Tool Kit, General Mechanic's
Gasket, Drain Flange (1)
Hammer, Hand, Plastic; item 16, Appx F
Lockwasher, M5 (2)
Caliper, Vernier; item 6, Appx F
Lockwasher, M6 (2)
Press, Arbor (Puller Kit and Press Frame); item 21,
Equipment Condition
Press, Rod; item 53, Appx F
Compactor set on level ground in a protected area.
Wrench, Torque; item 50, Appx F
Engine off.
Materials/Parts
Oil drained.
Solvent, Dry Cleaning; item 9, Appx E
General Safety Instructions
oil, Lubricating; item 6, Appx E
Observe all WARNINGS and CAUTIONS
2.
Remove the oil filler cap (Para. 4-15).
3.
Remove the dipstick (Para. 4-16)
NOTE
Removal of the gear cover may be re-
4.
Remove the crank handle guide assembly
quired for a variety of reasons. In many
cases not all components mounted on or
in the gear cover will need to be removed
5.
Remove the valve cover (Para. 4-33).
to accomplish a necessary repair or re-
placement. Determine removal needs by
6.
Remove the rocker arm assemblies and push
the access required to replace a defective
rods (Para. 5-7).
part. The procedure below provides for
complete removal to replace the gear
7.
Remove the fuel injector pump (Para. 5-5).
cover itself.
8.
Remove the compression release (Para. 5-10).
Disconnect the throttle control cable from the
1.
throttle control lever and engine bracket
5-37