TM 5-3695-376-14&P
5-13. CONNECTING ROD ASSEMBLY MAINTENANCE INSTRUCTIONS
This task includes:
d. Repair
a. Remove
e. Installation
b. Cleaning
c. Inspection
INITIAL SETUP
Gasket (1)
Tools
Tool Kit, General Mechanic's
Equipment Condition
Wrench, Torque; item 50, Appx F
Compactor set on level ground in a protected area.
Press, Arbor (Puller Kit and Press Frame); Item 21,
Engine off.
Oil drained.
Pressing Sleeve; item 28, Appx F
General Safety Instructions
Indicator, Dial; item 17, Appx F
Observe all WARNINGS and CAUTIONS
Materials/Parts
Solvent, Dry Cleaning; item 9, Appx E
Oil, Lubricating, Engine; item 6, Appx E
REMOVE
1.
Remove the engine from the compactor
Remove the cylinder head (Para. 5-8).
2.
Remove the piston assembly (Para. 5-12).
3.
Slowly crank the engine to bring the connecting
4.
rod to bottom dead center (BDC) of its stroke.
Set the engine down on the flywheel to provide
5.
access to the cover on bottom of the engine hous-
ing.
Remove six machine screws (1), cover (2), and
6.
gasket (3). Discard the gasket.
Determine if connecting rod (7) or bearing halves
7.
(8) require replacement by checking radial end
play of the connecting rod on the crankshaft jour-
nal as follows:
a.
Mount a dial indicator with stylus on the cen-
ter bottom of the connecting rod cap (6).
b. Grasp the connecting rod (7) at the top and
pull up firmly, while dial is zeroed.
5-33