TM 5-3895-376-14&P
Section II. MAINTENANCE PROCEDURES
5-3. ENGINE ASSEMBLY MAINTENANCE INSTRUCTIONS
This task includes:
a. Replace
INITIAL SETUP
Equipment Condition
Tools
Tool Kit, General Mechanic's
Compactor set on level ground in protected area.
General Safety Instructions
Materials/Parts
Observe all WARNINGS and CAUTIONS
Lockwasher, M10 (4)
Secure engine with four capscrews (1), lockwash-
9.
REPLACE
ers (2). flat washers (3) and two mounting
plates (4). Tighten the capscrews finger tight.
1.
Remove protection frame (Para. 4-23).
10. Install the clutch assembly (Para. 4-26), and
Remove v-belt cover (Para. 4-24).
2.
tighten capscrews (1) to 31-35 ft-lbs (43 - 48
Nm) torque.
Remove v-belt (Para. 4-25).
3.
11.
Install v-belt (Para. 4-25).
4.
Remove the clutch assembly (Para. 4-26).
5.
12 Install v-belt cover (Para. 4-24).
Disconnect the throttle control cable (Para. 4-18)
13. Connect the throttle control cable to the engine
6.
Remove four capscrews (1), lockwashers (2), flat
speed control lever and adjust control
washers (3) and two mounting plates (4).
7.
Attach a suitable hoist to the lift bracket on en-
14. Install the protection frame (Para. 4-23)
gine and lift engine assembly (5) from the engine
base.
NOTE
NOTE
Follow-on tasks include: Return unit to
service.
Engine weighs approximately 90 pounds.
Using hoist install replacement engine assem-
8.
bly (5) on engine base and align mounting holes
with slots in engine base.
5-4