TM 5-3805-296-23-1
0037
Table 1. 0562 Module Communication Diagnostic Codes Continued.
037
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
4. Using digital multimeter
0562-09 Caterpillar
Continuity Replace main cab wiring
(WP 0540), test for continuity
Monitoring System
harness (WP 0505). Replace fuse F40
between connector W-C7
Abnormal Update Rate
(TM 5-3805-296-10).
terminal 1 (WP 0012, Figure 252)
Continued
Proceed to Test Step 17.
and ground.
No Continuity Proceed to Test
Step 12.
Test Step 12. Test for Shorted Fuse
Panel Wiring Harness.
1. Using digital multimeter
Continuity Replace fuse panel wiring
(WP 0540), test for continuity
harness (WP 0515). Replace fuse F40
between connector CG-C1
(TM 5-3805-296-10).
terminal 23 (WP 0012, Figure 283)
Proceed to Test Step 17.
and all other terminals in CG-C1
No Continuity Proceed to step 2.
(WP 0012, Figure 283).
2. Using digital multimeter
Continuity Replace fuse panel wiring
(WP 0540), test for continuity
harness (WP 0515). Replace fuse F40
between connector CG-C1
(TM 5-3805-296-10).
terminal 23 (WP 0012, Figure 283)
Proceed to Test Step 17.
and ground.
No Continuity Replace tractor
operator monitor (WP 0506). Replace
fuse F40 (TM 5-3805-296-10).
Proceed to Test Step 17.
Test Step 13. Inspect Ground Point
of Cab Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Remove six bolts
(Figure 4,Item 1), washers
(Figure 4, Item 2), and step
(Figure 4, Item 3) from cab
(Figure 4, Item 4).
0037-10