TM 5-3805-296-23-1
0037
Table 1. 0562 Module Communication Diagnostic Codes Continued.
037
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 2. Test Ground Circuit
0562-09 Caterpillar
Function at Tractor Operator
Monitoring System
Voltage 18 to 25 V Proceed to Test
Monitor.
Abnormal Update Rate
Step 3.
Using digital multimeter (WP 0540),
Continued
Voltage Less Than 18 V Proceed to
test for voltage between connector
Test Step 13.
P-C18 terminal 1 and terminal 2
(WP 0012, Figure 269).
Test Step 3. Test Dash Wiring
Harness for High Resistance or
Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Remove upper and lower plenum
from ROPS (WP 0504).
3. Disconnect connector P-C1
(WP 0012, Figure 253)
from connector W-C7
(WP 0012, Figure 252).
4. Connect jumper wire between
terminal 53 and terminal 54
of connector P-C1
(WP 0012, Figure 253).
5. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 4.
between connector P-C18
Resistance Greater Than 5.0 Ohms
terminal 5 and terminal 14
Replace dash wiring harness
(WP 0012, Figure 269).
(WP 0510).
Proceed to Test Step 17.
0037-5