TM 5-3805-296-23-1
0037
Table 1. 0562 Module Communication Diagnostic Codes Continued.
037
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
3. Disconnect connector P-C1
0562-09 Caterpillar Monitor-
(WP 0012, Figure 253)
ing System Abnormal
from connector W-C7
Update Rate Continued
(WP 0012, Figure 252).
4. Using digital multimeter
Continuity Replace dash wiring
(WP 0540), test for continuity
harness (WP 0510). Replace fuse F40
between connector P-C1
(TM 5-3805-296-10).
terminal 1 (WP 0012, Figure 253)
Proceed to Test Step 17.
and all other terminals
No Continuity Proceed to step 5.
in connector P-C1
(WP 0012, Figure 253).
5. Using digital multimeter
Continuity Replace dash wiring
(WP 0540), test for continuity
harness (WP 0510). Replace fuse F40
between connector P-C18
(TM 5-3805-296-10).
terminal 1 (WP 0012, Figure 269)
Proceed to Test Step 17.
and all other terminals
No Continuity Proceed to step 6.
in connector P-C18
(WP 0012, Figure 269).
6. Using digital multimeter
Continuity Replace dash wiring
(WP 0540), test for continuity
harness (WP 0510). Replace fuse F40
between connector P-C18
(TM 5-3805-296-10).
terminal 1 (WP 0012, Figure 269)
Proceed to Test Step 17.
and ground.
No Continuity Proceed to Test
Step 11.
Test Step 11. Test for Shorted Main
Cab Wiring Harness.
1. Disconnect connector CG-C1
(WP 0012, Figure 283)
from connector W-C8
(WP 0012, Figure 282).
2. Using digital multimeter
Continuity Replace main cab wiring
(WP 0540), test for continuity
harness (WP 0505). Replace fuse F40
between connector W-C8
(TM 5-3805-296-10).
terminal 23 (WP 0012, Figure 282)
Proceed to Test Step 17.
and all other terminals
No Continuity Proceed to step 3.
in connector W-C8
(WP 0012, Figure 282).
3. Using digital multimeter
Continuity Replace main cab wiring
(WP 0540), test for continuity
harness (WP 0505). Replace fuse F40
between connector W-C7
(TM 5-3805-296-10).
terminal 1 (WP 0012, Figure 252)
Proceed to Test Step 17.
and all other terminals
No Continuity Proceed to step 4.
in connector W-C7
(WP 0012, Figure 252).
0037-9