TM 5-3805-296-23-1
0037
Table 1. 0562 Module Communication Diagnostic Codes Continued.
037
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 16. Test Dash Wiring
0562-09 Caterpillar
Harness for High Resistance or
Monitoring System
Open.
Abnormal Update Rate
1. Connect connector P-C1
Continued
(WP 0012, Figure 253)
to connector W-C7
(WP 0012, Figure 252).
2. Disconnect connector P-C18
(WP 0012, Figure 269) from tractor
operator monitor.
3. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Replace tractor operator monitor
between connector P-C18
(WP 0506).
terminal 2 (WP 0012, Figure 269)
Proceed to Test Step 17.
and ground.
Resistance Greater Than 5.0 Ohms
Replace dash wiring harness
(WP 0510).
Proceed to Test Step 17.
Test Step 17. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
3. At MSD, check for active
562-9 Caterpillar Monitoring System
diagnostic codes (WP 0008).
Abnormal Update Rate Becomes
Inactive Proceed to step 4.
562-9 Caterpillar Monitoring System
Abnormal Update Rate Remains
Active Repeat troubleshooting from
the beginning.
4. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
5. If removed, install step
(Figure 4, Item 3), six washers
(Figure 4, Item 2), and bolts
(Figure 4, Item 1) on cab
(Figure 4, Item 4).
6. Install instrument panel
(Figure 5, Item 3) with six bolts
(Figure 5, Item 4) on ROPS
(Figure 5, Item 5).
7. Install right vent (Figure 5, Item 7)
with two bolts (Figure 5, Item 6)
on instrument panel
(Figure 5, Item 3).
0037-14