TM 5-3805-296-23-1
0022
Table 1. 0100 Engine Oil Pressure Sensor Diagnostic Codes Continued.
022
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
3. Remove four bolts
0100-03 Engine Oil Pressure
(Figure 1, Item 1), washers
Sensor Voltage Above
(Figure 1, Item 2), bushings
Normal Continued
(Figure 1, Item 3), and splash
shield (Figure 1, Item 4) from
machine.
Figure 1. Splash Shield and Retaining Hardware.
0022
4. Disconnect connector CM-C9
(WP 0012, Figure 26) from oil
pressure sensor connector
(WP 0012, Figure 25).
5. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
6. Using digital multimeter
Voltage Less Than 4.5 V Proceed to
(WP 0540), test for voltage
Test Step 2.
between connector CM-C9
Voltage 5.0 0.5 V Proceed to Test
terminal 1 and terminal 2
Step 3.
(WP 0012, Figure 26).
Test Step 2. Test Basic Engine
Wiring Harness for High Resistance
or Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Connect jumper wire between
terminal 1 and terminal 2
of connector CM-C9
(WP 0012, Figure 26).