TM 5-3805-296-23-1
0019
Table 1. 0041 Eight-Volt Sensor Supply Diagnostic Codes Continued.
019
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 2. Test for Shorted Engine
0041-03 8 Volt DC Supply
Interface Wiring Harness.
Voltage Above Normal
1. Remove four bolts
Continued
(Figure 1, Item 1), washers
(Figure 1, Item 2), bushings
(Figure 1, Item 3), and splash
shield (Figure 1, Item 4) from
machine.
Figure 1. Splash Shield and Retaining Hardware.
0019
2. Disconnect connector CM-C1
(WP 0012, Figure 30) from engine
ECM.
3. Disconnect connector CL-C1
(WP 0012, Figure 45) from engine
ECM.
4. Using digital multimeter
Continuity Replace engine interface
(WP 0540), test for continuity
wiring harness (WP 0211).
between connector CL-C3
Proceed to Test Step 3.
terminal 28 (WP 0012, Figure 86)
No Continuity Proceed to step 5.
and all other terminals
in connector CL-C3
(WP 0012, Figure 86).
5. Using digital multimeter
Continuity Replace engine interface
(WP 0540), test for continuity
wiring harness (WP 0211).
between connector CL-C1
Proceed to Test Step 3.
terminal 4 (WP 0012, Figure 45)
No Continuity Proceed to step 6.
and all other terminals
in connector CL-C1
(WP 0012, Figure 45).