TM 5-3805-296-23-1
0018
Table 1. 0006 Fuel Injector Diagnostic Codes Continued.
018
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 3. Test for Shorted Basic
0006-06 Cylinder #6 Injector
Engine Wiring Harness.
Current Above Normal
1. Turn ignition switch and battery
Continued
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Lower left frame access plate
(WP 0376).
3. Remove four bolts
(Figure 9, Item 1), washers
(Figure 9, Item 2), bushings
(Figure 9, Item 3), and splash
shield (Figure 9, Item 4) from
machine.
Figure 9. Splash Shield and Retaining Hardware.
0018
4. Disconnect connector CM-C1
(WP 0012, Figure 30) from engine
ECM.
5. Using digital multimeter
Continuity Replace basic engine
(WP 0540), measure resistance
wiring harness (WP 0251).
between connector CM-C1
Proceed to Test Step 4.
terminal 105 (WP 0012, Figure 30)
No Continuity Proceed to step 6.
and all other terminals
in connector CM-C1
(WP 0012, Figure 30).
6. Using digital multimeter
Continuity Replace basic engine
(WP 0540), measure resistance
wiring harness (WP 0251).
between connector CM-C1
Proceed to Test Step 4.
terminal 105 (WP 0012, Figure 30)
No Continuity Replace engine ECM
and ground.
(WP 0252).
Proceed to Test Step 4.