TM 5-3895-376-14&P
5-18. OIL PUMP MAINTENANCE INSTRUCTIONS
This task includes:
a. Remove
c. Inspection
d. Installation
b. Cleaning
INITIAL SETUP
Equipment Condition
Tools
Tool Kit, General Mechanic's
Compactor set on level ground in a protected area.
Engine off.
Wrench, Torque, item 52, Appx F
Oil drained.
Materials/Parts
General Safety Instructions
Solvent, Dry Cleaning; item 9, Appx E
Gasket (1)
Observe all WARNINGS and CAUTIONS
Lockwasher, M6 (3)
1. Remove the gear cover (Para. 5-14).
2. Remove capscrew (1), two capscrews (2), lock-
washers (3) and remove oil pump (4) and gas-
ket (5) from the engine housing. Discard the
gasket.
NOTE
The oil pump (4) will separate into two
parts, do not misplace the thin cover plate.
CLEANING
WARNING
P-D-680, Type III is moderately toxic to
the skin. eyes and respiratory tract;
2 . Ensure that all gasket material is removed from
avoid prolonged exposure. Skin and
face of pump (4) and from mounting surface of
eye protection is required. Good ventila-
the engine housing.
tion is required. Do not use near open
flame or excessive heat. Flash point is
3. Clean other parts in dry cleaning solvent and dry
200F (93.3C).
thoroughly.
1. Clean the exterior of pump (4) with a rag damp-
ened with dry solvent and thoroughly.
5-52
