TM 5-3895-376-14&P
5-16. GOVERNOR (SPEED) CONTROL SHAFT MAINTENANCE INSTRUCTIONS - Continued
8.
Install control plate (11) and assembled speed
INSTALLATION
control levers (2 and 14) on end of shaft (12), en-
gaging small hole of lever (2) with pin on shoul-
1.
Lay the assembled gear cover down on suitable
der of shaft (12). Secure with lockwasher (10)
blocking with the inside facing up.
and nut (9).
2.
If removed, install the shouldered bolt (22) in
9.
Slide outer return spring (4) over the shaft (12),
boss on gear cover and tighten securely.
and hook spring leg in the notch at middle of the
control plate (11).
3.
If removed, install bracket (18), securing with
nut (19), lockwasher (20) and capscrew (21).
10. Slowly insert the shaft (12) through the bushed
Tighten securely.
hole of gear cover and guide the assembled gov-
ernor arm (5) onto the shaft. With the control
4.
If removed, install outer speed control lever (14)
lever (2) turned down and yoke of governor
to inner speed control lever (2), securing with hex
arm (5) up, work the leg of return spring (3) into
nut (15), lockwasher (16) and capscrew (17).
notch on end of the shaft (12).
5.
Coat new preformed packing (13) with lubricating
11. Continue to push the shaft (12) in while turning
oil and install in outer groove of speed control
the control lever (2) counterclockwise to horizon-
shaft (12).
tal, lifting governor arm to clear primer and engag-
ing yoke of governor arm (5) with the small pin on
6.
Install adjusting screw (8), locking tab (6) and cas-
lever of the fuel injection pump. Secure shaft with
tle nut (7) on the governor arm (5). Do not bend
retaining spring (1) when groove is fully visible in-
locking tab at this time.
side the gear cover.
7.
Install inner return spring (3) in governor arm (5),
positioning as noted during removal.
5-46
