TM 5-3895-376-14&P
5-16. GOVERNOR (SPEED) CONTROL SHAFT MAINTENANCE INSTRUCTIONS
This task includes:
d. Inspection
a. Adjust
e. Installation
b. Remove
c. Cleaning
INITIAL SETUP
Lockwasher, M6 (2)
Tools
Lockwasher, M8 (1)
Tool Kit, General Mechanic's
Caliper, Vernier; item 6, Appx F
Equipment Condition
Compactor set on level ground in protected area.
Materials/Parts
Engine off.
Solvent, Dry Cleaning; item 9, Appx E
Oil Drained.
Oil, Lubricating; item 6, Appx E
Gasket (1)
General Safety Instructions
Packing, Preformed (1)
Observe all WARNINGS and CAUTIONS
Locking Tab (1)
ADJUST
NOTE
Adjustment of the governor (speed) control
shaft must be made when the governor
has been repaired and/or the gear cover or
governor (speed) control shaft assembly
has been removed and reinstalled.
1.
If not already removed, remove the two cap-
screws (1), copper washers (2), inspection
cover (3), and gasket (4) from the gear cover.
5-43