TM 5-3805-296-23-5
0369
CLEANING AND INSPECTION
000369
Clean and inspect all parts IAW Mechanical General Maintenance Instructions (WP 0539).
END OF TASK
INSTALLATION
000369
1. Install brake drum on wheel (WP 0339).
2. Install bearing and oil seal on wheel (WP 0370).
3. Attach sling (Figure 5, Item 2) and lifting device to rear wheel (Figure 5, Item 1).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure
to follow this warning may result in injury or death to personnel.
NOTE
Rear wheel and brake rotor assembly weighs lb 925 lb (420 kg).
4. Using lifting device, install rear wheel (Figure 5, Item 1) on rear axle housing (Figure 5, Item 4).
5. Install bearing (Figure 5, Item 3) on rear wheel (Figure 5, Item 1).
Figure 5. Rear Wheel.
0369
