TM 5-3805-296-23-2
0146
for
Table 1. Left Rear Turn/Stop Light Does Not Operate.
0146
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
NOTE
Left Rear Turn/Stop Light
Does Not Operate
Always inspect harness connectors that are involved in the circuit. Poor
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
Test Step 1. Verify Condition.
No Proceed to Test Step 2.
Were you directed here from All Lights,
Yes Proceed to Test Step 10.
Horn, and Backup Alarm Fail To
Operate (WP 0141)?
Test Step 2. Test Voltage to Left Rear
Turn/Stop Light.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Remove two bolts
(Figure 1, Item 4), washers
(Figure 1, Item 1), and cover
(Figure 1, Item 2) from rear
blackout lamp housing
(Figure 1, Item 3).
Figure 1. Cover and Retaining Hardware on Rear Blackout Lamp Housing.
0146
