TM 5-3805-296-23-2
0146
Table 1. Left Rear Turn/Stop Light Does Not Operate Continued.
0146
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
8. Using digital multimeter
Left Rear Turn/Stop Light
Voltage 18 to 26 V Have assistant
(WP 0540), test for voltage
Does Not Operate
release brakes.
between connector AH-C10
Continued
Turn mode switch on military light
(WP 0012, Figure 185) and
switch to OFF position
connector AH-C13 (WP 0012,
(TM 5-3805-296-10).
Figure 188) while assistant applies
Turn ignition switch and battery
brakes (TM 5-3805-296-10).
disconnect switch to OFF position
(TM 5-3805-296-10).
Replace left rear blackout lamp
(WP 0352).
Proceed to Test Step 17.
Voltage Less Than 18 V Have
assistant release brakes.
Turn mode switch on military light
switch to OFF position
(TM 5-3805-296-10).
Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
Proceed to Test Step 3.
Test Step 3. Test Tail Lights/Backup
Alarm Wiring Harness for High
Resistance or Open.
1. Disconnect connector AH-C1
(WP 0012, Figure 325)
from connector AE-C4
(WP 0012, Figure 174).
2. Connect jumper wire between
connector AH-C1 terminal 6
and terminal 10
(WP 0012, Figure 325).
3. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 4.
between connector AH-C10
Resistance Greater Than 5.0 Ohms
(WP 0012, Figure 185)
Remove jumper wire from connector
and connector AH-C13
AH-C1 terminal 6 and terminal 10
(WP 0012, Figure 188).
(WP 0012, Figure 325).
Replace tail lights/backup alarm wiring
harness (WP 0351).
Proceed to Test Step 17.
Test Step 4. Test Draft Frame and
Bowl Side Wiring Harness for High
Resistance or Open.
1. Remove jumper wire from
connector AH-C1 terminal 6
and terminal 10
(WP 0012, Figure 325).
0146-4