TM 5-3805-296-23-2
0146
Table 1. Left Rear Turn/Stop Light Does Not Operate Continued.
0146
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 6. Test Chassis Wiring
Left Rear Turn/Stop Light
Harness for High Resistance or
Does Not Operate
Open.
Continued
1. Remove jumper wire from connec-
tor E-C2 terminal 16
and terminal 31
(WP 0012, Figure 143).
2. Disconnect connector J-C8
(WP 0012, Figure 100)
from connector W-C1
(WP 0012, Figure 99).
3. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to step 4.
between connector J-C8
Resistance Greater Than 5.0 Ohms
terminal 58 (WP 0012, Figure 100)
Replace chassis wiring harness
and connector J-C6 terminal 26
(WP 0305).
(WP 0012, Figure 141).
Proceed to Test Step 17.
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 7.
between connector J-C6
Resistance Greater Than 5.0 Ohms
terminal 12 (WP 0012, Figure 141)
Replace chassis wiring harness
and ground.
(WP 0305).
Proceed to Test Step 17.
Test Step 7. Test Main Cab Wiring
Harness for High Resistance or
Open.
1. Remove upper plenum from ROPS
(WP 0504).
2. Disconnect connector P-C1
(WP 0012, Figure 253) connector
W-C7 (WP 0012, Figure 252).
3. Using digital multimeter (WP 0540)
Resistance 5.0 Ohms or Less
and assistance, measure
Proceed to Test Step 8.
resistance between connector
Resistance Greater Than 5.0 Ohms
W-C7 terminal 45 (WP 0012,
Replace main cab wiring harness
Figure 252) and connector W-C1
(WP 0505).
terminal 58 (WP 0012, Figure 99).
Proceed to Test Step 17.
Test Step 8. Test Dash Wiring
Harness for High Resistance or
Open.
1. Disconnect connector P-C2
(WP 0012, Figure 265)
from connector N-C1
(WP 0012, Figure 264).
0146-6