TM 5-3805-296-23-2
0093
Table 1. 0096 Fuel Level Sensor Diagnostic Code Continued.
093
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
5. Using digital multimeter
0096-03 Fuel Level Sensor
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Voltage Above Normal
Proceed to Test Step 16.
between connector W-C1
Continued
Resistance Greater Than 5.0 Ohms
terminal 12 (WP 0012, Figure 99)
Replace main cab wiring harness
and connector W-C7 terminal 11
(WP 0505).
(WP 0012, Figure 252).
Proceed to Test Step 17.
Test Step 14. Inspect Ground Point
of Main Cab Wiring Harness.
1. Remove six bolts
(Figure 5, Item 1), washers
(Figure 5, Item 2), and step
(Figure 5, Item 3) from cab
(Figure 5, Item 4).
Figure 5. Cab Step.
0093
Ground Point or Ring Terminal Dirty
2. Inspect ground point of main cab
or Corroded Clean as necessary.
wiring harness (WP 0012,
Figure 316) for dirt, corrosion, and
Proceed to Test Step 17.
damage.
Ring Terminal Defective Replace
main cab wiring harness (WP 0505).
Proceed to Test Step 17.
No Problem Found Install main cab
wiring harness on ground point
(WP 0505). Proceed to Test Step 15.
