TM 5-3805-296-23-2
0093
Table 1. 0096 Fuel Level Sensor Diagnostic Code Continued.
093
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
2. Connect jumper wire between
0096-03 Fuel Level Sensor
terminal 1 and terminal 2 of
Voltage Above Normal
connector AF-C6
Continued
(WP 0012, Figure 172).
3. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
96-3 Fuel Level Sensor Voltage
4. At MSD, check for active
Above Normal Remains Active
diagnostic code 96-3 Fuel Level
Proceed to Test Step 9.
Sensor Voltage Above Normal
96-3 Fuel Level Sensor Voltage
(WP 0008).
Above Normal Becomes Inactive
Replace fuel level sender (WP 0446).
Proceed to Test Step 17.
Test Step 9. Test Push Frame Wiring
Harness for High Resistance or
Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Do not remove jumper wire from
terminal 1 and terminal 2 of
connector AF-C6
(WP 0012, Figure 172).
3. Disconnect connector AF-C1
(WP 0012, Figure 164) from
connector AE-C2
(WP 0012, Figure 163).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 10.
between connector AF-C1
Resistance Greater Than 5.0 Ohms
terminal 5 and terminal 12
Replace push frame wiring harness
(WP 0012, Figure 164).
(WP 0347).
Proceed to Test Step 17.
Test Step 10. Test Draft Frame and
Bowl Side Wiring Harness for High
Resistance or Open.
1. Remove jumper wire from
terminal 1 and terminal 2 of
connector AF-C6 (WP 0012,
Figure 172).
2. Connect jumper wire between
terminal 5 and terminal 12 of
connector AE-C2
(WP 0012, Figure 163).
0093-8
