TM 5-3805-296-23-2
0093
Table 1. 0096 Fuel Level Sensor Diagnostic Code Continued.
093
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
3. Disconnect connector AE-C1
0096-03 Fuel Level Sensor
(WP 0012, Figure 144) from
Voltage Above Normal
connector E-C2
Continued
(WP 0012, Figure 143).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 11.
between connector AE-C1
Resistance Greater Than 5.0 Ohms
terminal 17 and terminal 19
Replace draft frame and bowl side
(WP 0012, Figure 144).
wiring harness (WP 0280).
Proceed to Test Step 17.
Test Step 11. Test Hitch Wiring
Harness for High Resistance or
Open.
1. Remove jumper wire from terminal
5 and terminal 12 of connector
AE-C2 (WP 0012, Figure 163).
2. Connect jumper wire between
terminal 17 and terminal 19 of
connector E-C2
(WP 0012, Figure 143).
3. Lower left frame access plate
(WP 0376).
4. Remove four bolts
(Figure 4, Item 1), washers
(Figure 4, Item 2), bushings
(Figure 4, Item 3), and splash
shield (Figure 4, Item 4) from
machine.
Figure 4. Splash Shield and Retaining Hardware.
0093