TM 5-3805-296-23-2
0093
Table 1. 0096 Fuel Level Sensor Diagnostic Code Continued.
093
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
5. Disconnect connector E-C3
0096-03 Fuel Level Sensor
(WP 0012, Figure 142) from
Voltage Above Normal
connector J-C6
Continued
(WP 0012, Figure 141).
6. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 12.
between connector E-C3
Resistance Greater Than 5.0 Ohms
terminal 15 and terminal 27
Replace hitch wiring harness
(WP 0012, Figure 142).
(WP 0401).
Proceed to Test Step 17.
Test Step 12. Test Chassis Wiring
Harness for High Resistance or
Open.
1. Remove jumper wire from
terminal 17 and terminal 19 of
connector E-C2 (WP 0012,
Figure 143).
2. Connect jumper wire between
terminal 15 and terminal 27 of
connector J-C6
(WP 0012, Figure 141).
3. Disconnect connector J-C8
(WP 0012, Figure 100) from
connector W-C1
(WP 0012, Figure 99).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 13.
between connector J-C8
Resistance Greater Than 5.0 Ohms
terminal 12 and terminal 69
Replace chassis wiring harness
(WP 0012, Figure 100).
(WP 0305).
Proceed to Test Step 17.
Test Step 13. Test Main Cab Wiring
Harness for High Resistance or
Open.
1. Remove jumper wire from terminal
15 and terminal 27 of connector
J-C6 (WP 0012, Figure 141).
2. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to step 3.
between connector W-C1
Resistance Greater Than 5.0 Ohms
terminal 69 (WP 0012, Figure 99)
Proceed to Test Step 14.
and ground.
3. Remove upper and lower plenum
from ROPS (WP 0504).
4. Disconnect connector P-C1
(WP 0012, Figure 253) from
connector W-C7
(WP 0012, Figure 252).
0093-10