TM 5-3805-296-23-1
0064
Table 1. 0700 Transmission Gear Position Sensor Diagnostic Codes Continued.
064
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 4. Test for Shorted Chassis
0700-03 Transmission Gear
Wiring Harness.
Sensor Voltage Above
1. Disconnect connector J-C8
Normal Continued
(WP 0012, Figure 100)
from connector W-C1
(WP 0012, Figure 99).
2. Using digital multimeter
Continuity at Any Test Point
(WP 0540), test for continuity
Replace chassis wiring harness
between the following:
(WP 0305).
a. Connector J-C3 terminal 30
Proceed to Test Step 13.
(WP 0012, Figure 101) and all
No Continuity at Any Test Point
other terminals in connector
Proceed to Test Step 5.
J-C3 (WP 0012, Figure 101).
b. Connector J-C3 terminal 29
(WP 0012, Figure 101) and all
other terminals in connector
J-C3 (WP 0012, Figure 101).
c.
Connector J-C3 terminal 28
(WP 0012, Figure 101) and all
other terminals in connector
J-C3 (WP 0012, Figure 101).
d. Connector J-C3 terminal 27
(WP 0012, Figure 101) and all
other terminals in connector
J-C3 (WP 0012, Figure 101).
e. Connector J-C3 terminal 26
(WP 0012, Figure 101) and all
other terminals in connector
J-C3 (WP 0012, Figure 101).
f.
Connector J-C3 terminal 25
(WP 0012, Figure 101) and all
other terminals in connector
J-C3 (WP 0012, Figure 101).
0064-30