TM 5-3805-296-23-1
0064
Table 1. 0700 Transmission Gear Position Sensor Diagnostic Codes Continued.
064
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 18. Test Transmission
0700-02 Transmission Gear
Wiring Harness for High Resistance
Sensor Erratic, Intermittent,
or Open.
or Incorrect Continued
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector A-C1
(WP 0012, Figure 106)
from connector J-C3
(WP 0012, Figure 101).
3. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 19.
between connector AG-C1
Resistance Greater Than 5.0 Ohms
terminal 2 (WP 0012, Figure 120)
Replace transmission wiring harness
and connector A-C1 terminal 31
(WP 0266).
(WP 0012, Figure 106).
Proceed to Test Step 20.
Test Step 19. Test Chassis Wiring
Harness for High Resistance or
Open.
1. Disconnect connector J-C8
(WP 0012, Figure 100)
from connector W-C1
(WP 0012, Figure 99).
2. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Replace main cab wiring harness
between connector J-C3
(WP 0505).
terminal 31 (WP 0012, Figure 101)
Proceed to Test Step 20.
and connector J-C8 terminal 44
Resistance Greater Than 5.0 Ohms
(WP 0012, Figure 100).
Replace chassis wiring harness
(WP 0305).
Proceed to Test Step 20.
Test Step 20. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Turn battery disconnect switch to
ON position, start engine, depress
brake pedal, and move gear shift
lever into each gear position and
then back to neutral
(TM 5-3805-296-10).
3. At MSD, check for active
700-2 Transmission Gear Sensor
Erratic, Intermittent, or Incorrect
diagnostic codes (WP 0008).
Becomes Inactive Proceed to step 4.
700-2 Transmission Gear Sensor
Erratic, Intermittent, or Incorrect
Remains Active Repeat
troubleshooting from the beginning.
0064-26