TM 5-3805-296-23-1
0064
Table 1. 0700 Transmission Gear Position Sensor Diagnostic Codes Continued.
064
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
f.
Connector AG-C1 terminal 1
0700-03 Transmission Gear
and terminal 10
Sensor Voltage Above
(WP 0012, Figure 120).
Normal Continued
4. Using digital multimeter
Voltage 18 to 25 V Proceed to Test
(WP 0540), test for voltage
Step 6.
between connector AG-C1
Voltage Less Than 18 V Proceed to
terminal 2 and terminal 10
Test Step 11.
(WP 0012, Figure 120).
Test Step 3. Test for Shorted
Transmission Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector A-C1
(WP 0012, Figure 106)
from connector J-C3
(WP 0012, Figure 101).
3. Using digital multimeter
Continuity at Any Test Point
(WP 0540), test for continuity
Replace transmission wiring harness
between the following:
(WP 0266).
a. Connector A-C1 terminal 30
Proceed to Test Step 13.
(WP 0012, Figure 106) and all
No Continuity at Any Test Point
other terminals in connector
Proceed to Test Step 4.
A-C1 (WP 0012, Figure 106).
b. Connector A-C1 terminal 29
(WP 0012, Figure 106) and all
other terminals in connector
A-C1 (WP 0012, Figure 106).
c.
Connector A-C1 terminal 28
(WP 0012, Figure 106) and all
other terminals in connector
A-C1 (WP 0012, Figure 106).
d. Connector A-C1 terminal 27
(WP 0012, Figure 106) and all
other terminals in connector
A-C1 (WP 0012, Figure 106).
e. Connector A-C1 terminal 26
(WP 0012, Figure 106) and all
other terminals in connector
A-C1 (WP 0012, Figure 106).
f.
Connector A-C1 terminal 25
(WP 0012, Figure 106) and all
other terminals in connector
A-C1 (WP 0012, Figure 106).
0064-29