TM 5-3805-296-23-1
0064
Table 1. 0700 Transmission Gear Position Sensor Diagnostic Codes Continued.
064
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
4. Inspect harness connector A-C9
0700-03 Transmission Gear
Wiring Harness/Connector Damaged
(WP 0012, Figure 122),
Sensor Voltage Above
Replace transmission wiring harness
harness connector AG-C2
Normal Continued
(WP 0266).
(WP 0012, Figure 121), and
Proceed to Test Step 13.
harness connector AG-C1
No Problem Found Proceed to
(WP 0012, Figure 120) for damage
step 5.
IAW Electrical General
Maintenance Instructions
(WP 0540).
Tractor Actual Gear Switch Damaged
5. Inspect tractor actual gear switch
Replace tractor actual gear switch
for damage IAW (WP 0273) and
Electrical General Maintenance
(WP 0273).
Instructions (WP 0540).
Proceed to Test Step 13.
No Problem Found Proceed to Test
Step 2.
Test Step 2. Test Voltage to Tractor
Actual Gear Switch.
1. Connect connector A-C9
(WP 0012, Figure 122)
to connector AG-C2
(WP 0012, Figure 121).
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
NOTE
Diagnose and repair any circuit found to have voltage greater than 12.5 V
before diagnosing other circuits.
3. Using digital multimeter
Voltage Greater Than 12.5 V at Any
(WP 0540), test for voltage
Test Point Proceed to Test Step 3.
between the following:
Voltage 11.2 to 12.5 V at All Test
a. Connector AG-C1 terminal 9
Points Proceed to step 4.
and terminal 10
Voltage Less Than 11.2 V at Any Test
(WP 0012, Figure 120).
Point Proceed to Test Step 7.
b. Connector AG-C1 terminal 7
and terminal 10
(WP 0012, Figure 120).
c.
Connector AG-C1 terminal 6
and terminal 10
(WP 0012, Figure 120).
d. Connector AG-C1 terminal 3
and terminal 10
(WP 0012, Figure 120).
e. Connector AG-C1 terminal 4
and terminal 10
(WP 0012, Figure 120).
0064-28