TM 5-3805-296-23-1
0064
Table 1. 0700 Transmission Gear Position Sensor Diagnostic Codes Continued.
064
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 15. Test Chassis Wiring
0700-02 Transmission Gear
Harness for High Resistance or
Sensor Erratic, Intermittent,
Open.
or Incorrect Continued
1. Disconnect connector J-C8
(WP 0012, Figure 100)
from connector W-C1
(WP 0012, Figure 99).
2. Using digital multimeter
Resistance 5.0 Ohms or Less at All
(WP 0540), connect jumpers and
Test Points Proceed to Test Step 16.
measure resistance between the
Resistance Greater Than 5.0 Ohms at
following:
One or More Test Points Replace
a. Connect jumper wire between
chassis wiring harness (WP 0305).
terminal 38 and 39
Proceed to Test Step 20.
of connector J-C8
(WP 0012, Figure 100) and
measure resistance
between connector J-C3
terminal 30 and terminal 29
(WP 0012, Figure 101).
b. Remove jumper wire from
terminal 38 and 39 of
connector J-C8 (WP 0012,
Figure 100).
c.
Connect jumper wire between
terminal 37 and 64
of connector J-C8
(WP 0012, Figure 100) and
measure resistance
between connector J-C3
terminal 27 and terminal 28
(WP 0012, Figure 101).
d. Remove jumper wire from
terminal 37 and 64
of connector J-C8
(WP 0012, Figure 100).
0064-22