TM 5-3805-296-23-1
0031
Table 1. 0267 Engine Shutdown Switch Diagnostic Code Continued.
031
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 13. Test Hood Wiring
0267-02 Engine Shutdown
Harness for High Resistance or
Switch Erratic, Intermittent,
Open.
or Incorrect Continued
1. Connect jumper wire between
terminal A and terminal C
of connector L-C3
(WP 0012, Figure 223).
2. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 14.
between connector L-C1
Resistance Greater Than 5.0 Ohms
terminal 3 and terminal 5
Replace hood wiring harness
(WP 0012, Figure 190).
(WP 0389).
Proceed to Test Step 24.
Test Step 14. Test for Shorted
Chassis Wiring Harness.
1. Remove jumper wire from
terminal A and terminal C
of connector L-C3
(WP 0012, Figure 223).
2. Disconnect connector J-C8
(WP 0012, Figure 100)
from connector W-C1
(WP 0012, Figure 99).
3. Using digital multimeter
Continuity Replace chassis wiring
(WP 0540), test for continuity
harness (WP 0305).
between connector J-C2 terminal 5
Proceed to Test Step 24.
(WP 0012, Figure 189) and all
No Continuity Proceed to step 4.
other terminals in connector J-C2
(WP 0012, Figure 189).
4. Using digital multimeter
Continuity Replace chassis wiring
(WP 0540), test for continuity
harness (WP 0305).
between connector J-C8
Proceed to Test Step 24.
terminal 63 (WP 0012, Figure 100)
No Continuity Proceed to step 5.
and all other terminals
in connector J-C8
(WP 0012, Figure 100).
5. Using digital multimeter
Continuity Replace chassis wiring
(WP 0540), test for continuity
harness (WP 0305).
between connector J-C8
Proceed to Test Step 24.
terminal 63 (WP 0012, Figure 100)
No Continuity Proceed to Test
and ground.
Step 15.
0031-10