TM 5-3805-296-23-1
0031
Table 1. 0267 Engine Shutdown Switch Diagnostic Code Continued.
031
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
3. Using digital multimeter
0267-02 Engine Shutdown
Continuity Replace chassis wiring
(WP 0540), test for continuity
Switch Erratic, Intermittent,
harness (WP 0305).
between connector J-C2 terminal 3
or Incorrect Continued
Proceed to Test Step 24.
(WP 0012, Figure 189) and all
No Continuity Proceed to step 4.
other terminals in connector J-C2
(WP 0012, Figure 189).
4. Using digital multimeter
Continuity Replace chassis wiring
(WP 0540), test for continuity
harness (WP 0305).
between connector J-C8
Proceed to Test Step 24.
terminal 61 (WP 0012, Figure 100)
No Continuity Proceed to step 5.
and all other terminals in
connector J-C8 (WP 0012,
Figure 100).
5. Using digital multimeter
Continuity Replace chassis wiring
(WP 0540), test for continuity
harness (WP 0305).
between connector J-C8
Proceed to Test Step 24.
terminal 61 (WP 0012, Figure 100)
No Continuity Proceed to
and ground.
Test Step 7.
Test Step 7. Test Chassis Wiring
Harness for High Resistance or
Open.
1. Connect jumper wire between
terminal 3 and terminal 5
of connector J-C2
(WP 0012, Figure 189).
2. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 8.
between connector J-C8
Resistance Greater Than 5.0 Ohms
terminal 61 and terminal 63
Replace chassis wiring harness
(WP 0012, Figure 100).
(WP 0305).
Proceed to Test Step 24.
Test Step 8. Test for Shorted Main
Cab Wiring Harness.
1. Remove jumper wire from terminal
3 and terminal 5 of connector J-C2
(WP 0012, Figure 189).
2. Disconnect connector CL-C3
(WP 0012, Figure 86)
from connector W-C16
(WP 0012, Figure 87).
3. Using digital multimeter
Continuity Replace main cab wiring
(WP 0540), test for continuity
harness (WP 0505).
between connector W-C1
Proceed to Test Step 24.
terminal 61 (WP 0012, Figure 99)
No Continuity Proceed to step 4.
and all other terminals
in connector W-C1
(WP 0012, Figure 99).
0031-6