TM 5-3805-296-23-1
0031
Table 1. 0267 Engine Shutdown Switch Diagnostic Code Continued.
031
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
7. Using digital multimeter
0267-02 Engine Shutdown
Continuity Replace engine interface
(WP 0540), test for continuity
Switch Erratic, Intermittent,
wiring harness (WP 0211). Replace
between connector CL-C1
or Incorrect Continued
basic engine wiring harness (WP 0251).
terminal 23 (WP 0012, Figure 45)
Proceed to Test Step 24.
and all terminals in connector CM-
No Continuity Proceed to step 8.
C1 (WP 0012, Figure 30).
8. Using digital multimeter
Continuity Replace engine interface
(WP 0540), test for continuity
wiring harness (WP 0211).
between connector CL-C1
Proceed to Test Step 24.
terminal 23 (WP 0012, Figure 45)
No Continuity Proceed to Test
and ground.
Step 11.
Test Step 11. Test Engine Interface
Wiring Harness for High Resistance
or Open.
1. Connect jumper wire between
terminal 3 and terminal 31
of connector CL-C3
(WP 0012, Figure 86).
2. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Replace engine ECM (WP 0252).
between connector CL-C1
Proceed to Test Step 24.
terminal 23 and terminal 40
Resistance Greater Than 5.0 Ohms
(WP 0012, Figure 45).
Replace engine interface wiring
harness (WP 0211).
Proceed to Test Step 24.
Test Step 12. Test for Shorted Hood
Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector L-C1
(WP 0012, Figure 190)
from connector J-C2
(WP 0012, Figure 189).
3. Using digital multimeter
Continuity Replace hood wiring
(WP 0540), test for continuity
harness (WP 0389).
between connector L-C1
Proceed to Test Step 24.
terminal 5 (WP 0012, Figure 190)
No Continuity Proceed to step 4.
and all other terminals
in connector L-C1
(WP 0012, Figure 190).
4. Using digital multimeter
Continuity Replace hood wiring
(WP 0540), test for continuity
harness (WP 0389).
between connector L-C1
Proceed to Test Step 24.
terminal 5 (WP 0012, Figure 190)
No Continuity Proceed to Test
and ground.
Step 13.
0031-9