TM 5-3805-296-23-1
0024
Table 1. 0168 System Voltage Diagnostic Codes Continued.
024
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
0168-01 Electrical System
7. If lowered, install crankcase guard
Voltage Low Continued
(WP 0374).
8. Troubleshooting complete.
NOTE
0168-02 Electrical System
Voltage Erratic, Intermittent,
Always inspect harness connectors that are involved in the circuit. Poor
or Incorrect
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
DIAGNOSTIC CODE SET CONDITION
Engine ECM Detects Erratic Battery Voltage on Battery Circuits 150.
POSSIBLE CAUSE
Battery or Batteries.
Charging System.
Engine Interface Wiring Harness High Resistance or Open.
Main Cab Wiring Harness High Resistance or Open.
Fuse Panel Wiring Harness High Resistance or Open.
Circuit Breaker Panel.
Engine ECM.
Test Step 1. Test Batteries.
Perform battery testing on each battery
All Batteries Test Good Proceed to
(WP 0170).
Test Step 2.
One or More Batteries Fail Testing
Replace all batteries that failed testing
(WP 0306).
Proceed to Test Step 10.
Test Step 2. Test Charging System.
Perform charging system testing
Alternator Tests Good Proceed to
(WP 0169).
Test Step 3.
Alternator Fails Testing Replace
alternator (WP 0246).
Proceed to Test Step 10.