TM 5-3805-296-23-1
0024
Table 1. 0168 System Voltage Diagnostic Codes Continued.
024
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Voltage 18 to 25 V Proceed to Test
0168-01 Electrical System
9. Using digital multimeter
Step 5.
Voltage Low Continued
(WP 0540), test for voltage
Voltage Less Than 18 V Proceed to
between CL-C1 terminal 53
(WP 0012, Figure 45) and ground.
Test Step 8.
Test Step 5. Inspect Ground Points of
Engine Interface Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Lower crankcase guard
(WP 0374).
3. Inspect ground points of engine
Ground Point(s) or Ring Terminal(s)
interface wiring harness
Dirty or Corroded Clean as
(WP 0012, Figure 310, 313) for
necessary.
dirt, corrosion, and damage
Proceed to Test Step 10.
(WP 0540).
Ring Terminal(s) Defective Replace
engine interface wiring harness
(WP 0211).
Proceed to Test Step 10.
No Problem Found Install engine
interface wiring harness on ground
points (WP 0211). Proceed to
Test Step 6.
0024-6