TM 5-3805-296-23-1
0024
Table 1. 0168 System Voltage Diagnostic Codes Continued.
024
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
0168-01 Electrical System
7. Using digital multimeter
Resistance 5.0 Ohms or Less
Voltage Low Continued
(WP 0540), measure resistance
Replace fuse panel wiring harness
between connector W-C8
(WP 0515).
terminal 28 and terminal 29
Proceed to Test Step 10.
(WP 0012, Figure 282).
Resistance Greater Than 5.0 Ohms
Replace main cab wiring harness
(WP 0505).
Proceed to Test Step 10.
Test Step 10. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Turn battery disconnect switch to
ON position and start engine or
attempt to start engine
(TM 5-3805-296-10).
3. At MSD, check for active
168-1 Electrical System Voltage Low
diagnostic codes (WP 0008).
Becomes Inactive Proceed to step 4.
168-1 Electrical System Voltage Low
Remains Active Repeat
troubleshooting from the beginning.
4. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
5. If removed, install splash shield
(Figure 4, Item 4), four bushings
(Figure 4, Item 3), washers
(Figure 4, Item 2), and bolts
(Figure 4, Item 1) on machine.
Figure 4. Splash Shield and Retaining Hardware.
0024
6. If lowered, install left frame access
plate (WP 0376).