TM 5-3805-296-23-1
0021
Table 1. 0094 Fuel Pressure Sensor Diagnostic Codes Continued.
021
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 11. Test Engine Interface
0094-03 Fuel Pressure
Wiring Harness for High Resistance
Sensor Voltage Above
or Open.
Normal Continued
1. Remove jumper wire from
terminal 3 and terminal 2
of connector AW-C1
(WP 0012, Figure 36).
2. Connect jumper wire between
terminal 5 and terminal 4
of connector CL-C9
(WP 0012, Figure 33).
3. Disconnect connector CL-C10
(WP 0012, Figure 32)
from connector CM-C11
(WP 0012, Figure 31).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), test for continuity
Proceed to Test Step 12.
between connector CL-C10
Resistance Greater Than 5.0 Ohms
terminal 7 and terminal 6
Replace engine interface wiring
(WP 0012, Figure 32).
harness (WP 0211).
Proceed to Test Step 13.
Test Step 12. Test Basic Engine
Wiring Harness for High Resistance
or Open.
1. Remove jumper wire from
terminal 5 and terminal 4 of
connector CL-C9
(WP 0012, Figure 33).
2. Connect jumper wire between
terminal 7 and terminal 6
of connector CM-C11
(WP 0012, Figure 31).
3. Disconnect connector CM-C1
(WP 0012, Figure 30) from engine
ECM.
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Replace engine ECM (WP 0252).
between connector CM-C1
Proceed to Test Step 13.
terminal 17 and terminal 40
Resistance Greater Than 5.0 Ohms
(WP 0012, Figure 30).
Replace basic engine wiring harness
(WP 0251).
Proceed to Test Step 13.
0021-8