TM 5-3805-296-23-1
0021
Table 1. 0094 Fuel Pressure Sensor Diagnostic Codes Continued.
021
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 2. Test Fuel Filter Wiring
0094-03 Fuel Pressure
Harness for High Resistance or
Sensor Voltage Above
Open.
Normal Continued
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Connect jumper wire between
terminal 1 and terminal 2 of
connector AW-C1
(WP 0012, Figure 36).
3. Disconnect connector AW-C4
(WP 0012, Figure 34) from
connector CL-C9
(WP 0012, Figure 33).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 3.
between connector AW-C4
Resistance Greater Than 5.0 Ohms
terminal 3 and terminal 4
Replace fuel filter wiring harness
(WP 0012, Figure 34).
(WP 0233).
Proceed to Test Step 13.
Test Step 3. Test Engine Interface
Wiring Harness for High Resistance
or Open.
1. Remove jumper wire from
terminal 1 and terminal 2
of connector AW-C1
(WP 0012, Figure 36).
2. Connect jumper wire between
terminal 3 and terminal 4
of connector CL-C9
(WP 0012, Figure 33).
3. Disconnect connector CL-C10
(WP 0012, Figure 32)
from connector CM-C11
(WP 0012, Figure 31).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 4.
between connector CL-C10
Resistance Greater Than 5.0 Ohms
terminal 5 and terminal 6
Replace engine interface wiring
(WP 0012, Figure 32).
harness (WP 0211).
Proceed to Test Step 13.
0021-3