25
BEARING
REMOVAL
TOOL
PRESS
WIDE END OF
DRIVE SHAFT
ACCESS
HOLE
SUPPORT
FIXTURE
41
40
42
TM 9-4940-568-34
5-147
g.
Assembly of Drive Shaft and Clutch Group.
(1)
If disassembled, position drive shaft (37) on
work surface with internal gear end down
and assemble drive shaft and clutch group
(25), as follows:
Center support bearing is
permanently lubricated. Do not
add lubricant to this bearing.
NOTE
If center support bearing was
removed, perform Step (2) below
before proceeding with assembly.
(2)
With drive shaft (37) on, in a vise, place
bearing removal tool ends through access
holes in wide end of drive shaft and
squarely press center support bearing (42)
off of surface on center shaft.
(3)
Install drive shaft support (41) on drive shaft
(37), seating the center support bearing (42)
into drive shaft support.
(4)
Install clutch drive assembly (39) on drive
shaft (37).
(5)
Slide pinion stop (38) on drive shaft (37)
end with the recess for two stop rings (40)
face up.
(6)
Install two stop rings (40) in groove in drive
shaft (37).
