15
13
14
16
3
11
34
PLUNGER
3
PLUNGER
SPRING
SOLENOID
PLUNGER
SEALING
BOOT
PLUNGER
12
14
ARMATURE
GEAR
9
25
13
24
TM 9-4940-568-34
5-152
5-23. STARTER MOTOR REPAIR (CONT).
j.
Assembly of Frame and Field Assembly.
NOTE
Prior to performing Step (1),
position the assembled gear
reduction and drive group with
the pinion gear end down.
(1)
Using a tube that bears on the bearing inner
race only, press on commutator end
armature bearing (15) and/or drive end
armature bearing (14) until inner race
bottoms out against the shoulder on the
armature assembly (13) shaft.
(2)
Repeat Step (1) until both commutator end
armature bearing (15) and drive end
armature bearing (14) are installed on
armature assembly (13).
(3)
Pivot plunger of solenoid assembly (3) into
engagement with shift lever (34).
(4)
Position solenoid assembly (3) mounting
flange and install solenoid screws (16).
Tighten solenoid screws to 25 lb-in
(2.8 N.m).
(5)
Position assembled armature assembly (13)
into the drive shaft and clutch group (25).
(6)
Align gear teeth, and then seat drive end
armature bearing (14) on armature assembly
(13) shaft fully in armature support bracket
(24).
(7)
Install frame seal (11) on front of frame and
field assembly (9).
