6
4
9
8
1
3
7
5
5
9
TIMING
MARKS
2
1
3
TM 9-4940-568-34
5-155
2
(17)
Install two brush plate screws (6) in
commutator end frame (5) and brush holder
group (7). Torque two brush plate screws
to 25 lb-in (2.8 N.m).
(18)
Install two thru bolts (4) in commutator end
frame (5). Tighten thru bolts by hand but
do not close gap between commutator end
frame and frame and field assembly (9)
where preformed packing (8) goes.
(19)
Roll preformed packing (8) back down in
its installed position between commutator
end frame (5) and the frame and field
assembly (9).
(20)
Align timing ribs on edge of commutator
end frame (5) with timing spots on frame
and field assembly (9) to assure proper
brush alignment. Marks are located in two
places on motor but will match only one
way.
(21)
Tighten two thru bolts (4) to 75 lb-in (8.5
N.m).
(22)
Remove nut (1) from solenoid assembly
(3), install motor lead (2), and reinstall nut
(1) onto solenoid assembly (3).
(23)
Tighten nut (1) on terminal of solenoid
assembly (3) to 100 lb-in (11 N.m).
